Address: Da Lingshan Yeung Uk third industrial zone Dongguan City (Yang Lang roadside)
COPYRIGHT © 2018 Dongguan Dongyoyuan Machinery Co., Ltd. All Rights Reserved 粤ICP备15004812号
Power Injection Molding Machine Rapid Mold Change System Pump - Pump Unit
Mold quick change system mainly consists of the following parts: special mold, mold mold, from the mold, rail, pump station, electric control cabinet and accessories. Mold quick change system can achieve rapid tooling out of the table, up and down the mold automatically align, mold quickly tightened.
Action principle and characteristics:
1, the host outside the installation of rails, the host mounted spring from the mold. Replace the mold when the release clamp mold, spring from the top of the mold, and the host outside the rail in the same level, with the human body can be light up and down the mold (including abrasive) pulled out, hanging on the host outside the rail. Another ready to be changed mold mold, can be suspended by the crane on the host outside the rails, with the human body can be lightly pushed into the machine, so that the mold quickly into the table.
2, special mold design of the upper and lower center. Mold in place, do not have time and effort to adjust the upper and lower mold, the upper and lower mold from the machining size of the alignment, accurate, simple.
3, mold in place, with a clamping device instead of fastening screws, hydraulic drive clamp mold one-click to tighten or relax, simple operation, saving time and effort.
4, the hydraulic pump station using imported pneumatic pump, oil supply pressure, energy saving; preferred zero leakage solenoid valve and high-quality accessories, good sealing performance, safe and reliable.
5, with oil detection components, and electrical interconnection with the press, in case of accidents, resulting in accidents caused by lack of oil pressure caused by security incidents.
6, electronic control system can be integrated with the press control system.
The figure shows: Lijin injection molding machine rapid mold changing system system pump - pump unit 01
The figure shows: Lijin injection molding machine rapid mold changing system system pump - pump unit 02
Dongguan Dongyoyuan Machinery Co., Ltd.
Address: Guangdong Province, Da Lingshan Yeung Uk third industrial zone Dongguan City (Yang Lang roadside)